Wurlitzer 3600 Selection Accumulator issue

[md2020]

Hey there;
Got the service manual. I’ve run into an issue where 2 pins on the accumulator are not returning to the latched position.
Is it possible that it’s a spring issue? As in I replace the springs on those particular pins? I’ve done all the other things: readout alignment, pinbank adjustment etc. everything is working besides these 2 pins.
Any help would be appreciated. I’ve pulled the accumulator too many times now to watch it work. There are no bent pins as far as my eye can see

[Ron Rich]

Hey there, backatcha,
I am ASSuming you are speaking of the "Selection Accumulator". If so, that's going to be a mechanical problem--either the locking nub is broken off those 2 pins, or the slot in the ring has been "opened up" too far to catch the nub ? If my assumptions are correct, you can verify it by swapping pins from a known good position to the bad-- Ron Rich