Wurlitzer 1080 Emerson electric motorI (1140rpm)

[fil]

Hi,

I acquired a Wurlitzer 1080 and i am trying to restore/clean/oil it.  

I opened the electric motor (Emerson 1140 rpm) and in doing it i damaged two wires that were connected to a device screwed on one of the case cup. I was not able to find a diagram or manual for the motor and there is not any information in the Wurlitzer manual. I don't know where the wires were connected therefore i don't know where to soldering them.

Please can you help? Where can I find more info about the Emerson electric motor? Any good forum/site where to find info about vintage electric motor?

Thank you in advance 

Filippo

[Startgroove]

Filippo, those wires probably connect in series with the starter winding switch. At each end of the switch, there is a terminal, that is probably where those wire go. Upload a picture to confirm. Cheers, Russie

[fil]

Hi,

i was able to find the manufacture (KLIXON) and drawing of the thermostat relay and figured out the wiring

Below the link in case somebody else need it.

www.carbonbrush.com/schematicklixonsingle.jpg

Thank you anyhow for the help

Filippo