joda
New Member
Posts: 5
|
Post by joda on Mar 16, 2021 21:39:27 GMT
Hi there
I have had my 3210 for a couple of years and it has worked fine, but now the solonoids around the carousel have stopped working. If I manually push one in everything works.
I guess it is an electrical problem , I have looked through the wiring diagram but not really sure where to start . I would appreciate any guidance on where to look.
Many thanks
|
|
|
|
Post by Ron Rich on Mar 16, 2021 23:01:07 GMT
If it acts like it's selecting OK--Try manually pushing the circuit breaker for the solenoids ? More info needed to diagnose it-- try the trouble shooting guide in the Service Manual-- Ron Rich
|
|
joda
New Member
Posts: 5
|
Post by joda on Mar 17, 2021 7:40:39 GMT
Thanks for quick response. It all seems to select ok , I get credit , selection does what it should . I was thinking that if none of the solonoids work it must be the common feed , any idea where the circuit breaker is on this model
|
|
joda
New Member
Posts: 5
|
Post by joda on Mar 17, 2021 8:01:36 GMT
Read schematic and found cb ,all seems ok
|
|
|
|
Post by Ron Rich on Mar 17, 2021 12:37:28 GMT
If that worked -- clean up the selection relays-- see our FAQ's section posts. Ron Rich
|
|
joda
New Member
Posts: 5
|
Post by joda on Mar 17, 2021 14:07:17 GMT
Hi Ron rich
Thanks for the support
I meant I couldn’t see anything wrong with cb (the one behind the button bank) selector pin solonoids still not working🤔
Thanks
Joda
|
|
|
|
Post by Ron Rich on Mar 17, 2021 15:47:31 GMT
Hi Joda,
What do you expect to 'see" ? Some CB's show if opened, others do not-- to be sure, one must test them with an Analog meter ! Ron Rich
|
|
joda
New Member
Posts: 5
|
Post by joda on Mar 17, 2021 18:14:35 GMT
Hi Ron rich
I Studied the drawing and came to the same conclusion as you that the cb was open circuit . I removed selector switch socket 2 and did continuity test through pin 11 to Load side of cb and yep it was faulty.
Thank you so much for your help it’s much appreciated.
Joda
|
|
