|
|
Post by prime on Jun 11, 2022 23:16:44 GMT
Hi guys ive noticed my mute relay closes at the end of a record but in a few seconds opens again, if i touch it it will close again for a few seconds. Ive cleaned the connectors and the pins on the relay. I could try and open the casing and clean the contacts. Is this a must replace situation or am i not seeing the whole picture. pete
|
|
|
|
Post by prime on Jun 11, 2022 23:41:57 GMT
Just remembered an old post on cold solder joints on Rock-olas Ive decided to remove the board that the relay connects too ,then re flo all of the solder joints. pete
|
|
|
|
Post by Ron Rich on Jun 12, 2022 3:50:03 GMT
Hi Pete,
Whut is you "touching" ? Is his an "ice cube-plug in type", relay ? What "holds" the relay energized ? Ron Rich
|
|
|
|
Post by prime on Jun 12, 2022 17:23:48 GMT
Its the ice cube type, it was just moving a little side to side would open or close relay contact, I took out the board and retouched all of the solder joints, it seems to be ok now, i will be keeping an eye on it for the next 5 songs or so. Pete ps forgot to answer you question, cam switch 3 when in position starts the mute sequence. I had already checked it to make sure it was operating and clean.
|
|
|
|
Post by Ron Rich on Jun 12, 2022 18:05:22 GMT
Hi Pete,
Didja clean that relay ? Didja READ, the sticky on cleaning it ? Ron Rich
|
|
|
|
Post by prime on Jun 12, 2022 19:50:29 GMT
Hi Ron yes i cleaned the relay but i think one of the pins on the board was not soldered properly and would loose contact, thats why when i moved it left or right it would rock and cause contact, now its working perfectly. thanks again for the site. And the faq section, i use it allot. pete
|
|
