|
|
Post by Ron Rich on Mar 7, 2019 13:51:16 GMT
Travis,
Did you read the above sticky ? It says to "---remove EACH pin from the plug----"
Ron Rich
|
|
tman
New Member
Victoria, Australia
Posts: 10
|
Post by tman on Mar 10, 2019 23:36:07 GMT
Hi Ron
I had already removed each wire out of the connectors and cleaned them all when I was last there, so now I will run new ground wires and I also bought the other terminals which make contact on both sides of the pins unlike the original ones so they should have a better chance of making good contact, but I have not gone back there yet and will let you know how it goes. Thanks
Travis
|
|
|
|
Post by Ron Rich on Mar 11, 2019 2:21:23 GMT
Hi Travis,
Just be sure to check the soldering on those headders--OFTEN bad !!
Good Luck,
Ron Rich
|
|
tman
New Member
Victoria, Australia
Posts: 10
|
Post by tman on Mar 11, 2019 10:28:19 GMT
Hi Ron
I had re soldered all the headers on the mech decoder board even though they all looked OK, but I didn't do the CCC, but I should do that also anyway, but I might run the new earths first and see how that goes. Thanks
Travis
|
|
|
|
Post by Ron Rich on Mar 11, 2019 12:58:56 GMT
Travis,
I would not run "new" earths, unless you followed the exact specs. (other then wire size) the old ones used ! That phono (as are all Roew CD's) is subject to "Ground loops". Ron Rich
|
|
