Post by sooner on Apr 3, 2019 16:09:34 GMT
Like my previous SC1, the outer wiper arm on my latest seemed to be running on the very outer edge of the contacts so I decided to reform it so it would run closer to the middle. I made sure to mark it relative to the shaft this time to make it easier to get in back in the correct location. The best laid plans....
It was working fine before I tried to "fix" it. One dime for a single or two dimes for an LP side or 2 singles. Now after messing with it for over an hour the closest I get is it works okay but when 2 dimes are credited and a single is selected it runs two cycles instead of one.
Comparing to my other SC1 (that's working properly) I notice that when a dime is credited the wiper arm moves about 1/4" on the good one but only about 1/8" on the problem one.
It was working fine before I tried to "fix" it. One dime for a single or two dimes for an LP side or 2 singles. Now after messing with it for over an hour the closest I get is it works okay but when 2 dimes are credited and a single is selected it runs two cycles instead of one.
Comparing to my other SC1 (that's working properly) I notice that when a dime is credited the wiper arm moves about 1/4" on the good one but only about 1/8" on the problem one.