Matching Speakers

[nyjb]

I have a bunch of speakers taken from Seeburg Rs.  They have varying resistance measurements.  Is there any particular strategy for pairing them back up, other than keeping the original sets intact?  Should they be in pairs that have closely matched resistance?  Is there a total ohmage I should shoot for? Is there a high or low reading that would preclude a speaker's being used at all?  (They will run with the standard R receiver and amp.)

Thanks

[Ron Rich]

The WSR makes no difference- I would keep sets together by brand--Seeburg used three different brands in the R models--See your parts book.
Total resistance should be as shown on the MRA-5 schematic, in the Service Manual. Ron Rich