|
|
Post by Waynew on May 25, 2019 18:45:34 GMT
I have a Seeburg AY160 and it was playing as usual and all of a sudden it was moving to the right and got stuck. By the time I got to the machine to turn it off it already blew the fuse and circuit breaker. After checking it out I unplugged the mech from the TSU5 and replaced the fuse. Everything powered up as usual. I freed up the mech and move it to center of the rack manually. Now if I plug the mech back in and power on fuse is ok until the mech is triggered to move. It blows the fuse instantly. Where should I check next. I know the motor isn’t locked up it moves free.
|
|
|
|
Post by Ron Rich on May 25, 2019 20:38:16 GMT
Stare wit our FAQ's section, then the stickies above in this section----read the info on contact switches, and over-center switches--Your reversing switch is "welded", or broken !
Ron Rich
|
|
|
|
Post by Waynew on Jun 1, 2019 4:54:55 GMT
So after I replaced the reversing switch and plugged all the cables back in. I turn the machine in and it immediately starts to scan left and right. But doesn’t stop scanning?
|
|
|
|
Post by Ron Rich on Jun 1, 2019 13:50:39 GMT
Hi Wayne,
So ?? You fizzed it !! Do you have a copy of my "Seeburg Mechanism Guide" ?
Check the scan control coils in your TSU --does it stop if you use the service switch ?
Ron Rich
|
|
