gabor
New Member
Posts: 3
|
Post by gabor on Nov 6, 2019 19:20:19 GMT
Hello!
I have a Rowe Ami Ti 1 musicbox. My amplifier is an R-4359. My problem is that my two transformers are not receiving power and have only 1V instead of 70V at both A1 and A2 on both sides. What could be the problem? Anyone have any ideas?
Regards
Gabor
|
|
|
|
Post by Ron Rich on Nov 6, 2019 20:26:47 GMT
Hi Gabor,
How are you "measuring voltage" ? In this case the "70 volts" does not indicate that there is a steady 70 volts there, only that the maximum of 70 volts will be there. Do you not have enough volume from 70 volt speakers ? If that's the case, see the Service Manual for proper installation instructions for that phono. Ron Rich
|
|
gabor
New Member
Posts: 3
|
Post by gabor on Nov 7, 2019 7:54:07 GMT
Sorry everyone, but I'm a very beginner. I managed to get this nice music machine. Very I would like to fix it. All tubes were replaced, but unfortunately no sound. I mean the output transformers don't get any power. If anyone has any ideas write me where to look for the bug.
Unfortunately, it is very beginning or is here in a square. I think a two output transformer will not be powered. No sound at all. I replaced all tubes again, but nothing changed. However, if I connect my phone directly to the 2 RCA sockets on the amplifier, it will sound. What could be the problem?
Regards
Gabor
|
|
|
|
Post by Ron Rich on Nov 7, 2019 13:36:26 GMT
Hi Gabor,
If that phono has a pre amp, it could have problems, or you have problems from the needle, cartridge, to the wiring that runs to the amplifier. If you have a meter, check continuity, with the power OFF ! Ron Rich
|
|
