Seeburg Select-O-Matic LS2 not selecting U and V - UPDATE

[jfranco]

Hi,

Seeburg Select-O-Matic LS2 not selecting U and V sections, just scans across and back does not 'find' them, and stops.

A through T selections work fine.

This WAS bumped around during a move.

What am I looking to adjust?

Thanks!!!

[Ron Rich]

You are looking to "adjust" nothing-- You are looking to find out what has been bent ! Was the mech snubber block installed during the move ? Did you lay it on it's back-- obviously, I assume you did not tie it down properly ? I would look at the contact block (aka "frog") located under the TMU. Ron Rich

[jfranco]

Thanks Ron.

It was rolled, not put in its back, and strapped on a trailer standing up. Drove a few blocks and unloaded. Box itself was secure, but not internals.

Regretfully nothing was secured by the mover, as ignorance about moving jukeboxes was involved.
This is my first jukebox, I have the manual, so I will attempt to identify the contact block and TMU and take look.

Will post some pictures and video if I can not figure it out.

Thanks,

Joe

[jfranco]

I spent a little time on this today.
Here is a video of a selection of S3, which it picks up no problem. Then I select U3 and it scans and stops.
I did notice if I pick T3 it plays V3, T6 plays V6, etc. So when I pick anything above T, I am off the charts so to say.
Any selection from A to S works as it should.
Also, should that bracket be hanging off?
Any help on how I should proceed is appreciated.

Video:

www.youtube.com/shorts/_N--4m0JBJk

Pictures:

www.youtube.com/watch?v=sN_I1Q9rlSY

[Ron Rich]

Hi Joe,
Simple problem-- popularity meter actuator is not aligned with the drive pin, forcing a bind when it gets to the RH side. Wires should NOT "pull" meter actuator. ! Item you are holding in photo needs second screw and " drive pin needs to be properly inserted into actuator assembly--see the parts catalog -- Ron Rich

[jfranco]

Found missing screw at bottom of case, replaced and aligned as manual showed, all fixed!!!!
Thanks Ron!!
Joe

[Ron Rich]

Hi Joe,
Glad it's working- Thanks for the photo-I'd never have guessed on that one !
Ron Rich