bat47
New Member
Posts: 5
|
Post by bat47 on May 18, 2022 17:26:00 GMT
I am currently working on a Rowe RI-1 for a friend. The problem is the magazine will not move even in the scan mode. Everything else works fine. I have checked all switches and coils. I have a service manual but the electrical schematics are not in it. I have searched the internet and cannot find them . If anyone could give me some advice or point me in the right directions I would appreciate it.
|
|
|
|
Post by Ron Rich on May 18, 2022 18:13:11 GMT
More info needed-- since I have never seen this model--is it a 100 selection phono ? Does it have a "mech control computer" (MCC) on it--if so, which model # ? Is the gripper bow "homed" ? Ron Rich
|
|
bat47
New Member
Posts: 5
|
Post by bat47 on May 19, 2022 0:18:17 GMT
This one is a bit different than anything I have. Keep in mind that I am in new territory with jukeboxes. It only holds sixty records. It does not have a central computer. It has a pinwheel that keeps up with selections. When a selection is made a arm pushes the associated pin which I believe stops the magazine at the right spot. All the pins are retracted now. It does have a board but I don't find anything in the manual about it. The manual is very vague about how it works. It is also written in 3 different languages. I was hoping to find some electrical schematics so maybe I could tell a little more about it.
|
|
|
|
Post by Ron Rich on May 19, 2022 2:49:03 GMT
Please-- read and comply with the User Information, red-pined sticky, and the "Hi Newbies" post in our FAQ's section, so we can better help you-- Ron Rich
|
|
