|
|
Post by Lincoln on Feb 18, 2018 20:18:13 GMT
I now have my M100c up and going. In reading older posts I've run across different recommendations about adding fuses to protect different components (mainly the transformers) inside the selection receiver and amp. Would you guys give me your recommendations as to the locations and types of fuses to add to my machine. Does this apply mainly to the earlier tube type receivers, or are there one you would add to later models such as a PFEAIU.
|
|
|
|
Post by Ron Rich on Feb 21, 2018 17:25:13 GMT
Hi Lincoln,
I fuse the WSR's main transformer on the input AC line at 2.5 amps SB. I fuse the latch bar solenoid at the solenoid itself at 5 amps, if not using an electronic solenoid saver (NOT the one sold on eBay-cheap). If the rectifier has been changed, I fuse the incoming AC side at 1/2 amp. On the mechanism, I add a 1/4 to 1/2 amp,SB fuse in the pop meter/cancel coil circuit.
On the PFEA phono's, I add the same latch bar fuse--and change the 15 amp fuse on the 25 vac circuit to 7 or 7.5 amps. Ron Rich
|
|
