Seeburg 100b select light issue

[prime]

Hi guys i am bringing a 100 b back to full life and have an issue with the credit lights, I have tested both bulbs and they are ok, they are h 47 6.3 vlts/ In the photo below you can see a loose wire, appears to come from a solenoid , under the wire is a connector with three legs, on the far right i get 5.7 vlts, on the center that goes to the first light socket i get 13vlts, on the far left 0 i think its ground, if i remove the far right bulb i get 0 volts at middle pin, because the two sockets are in series i believe that confirms wireing between the two sockets, i am using a free play adaptor so power should always be at select lights. Can the loose wire cause an issue with the lights? if so does it go to the center leg?  Lastly i have been informed there should be a drop down resistor .      Pete

[jukenorman]

Hi Pete,
I'm afraid that you're going to have to get the manual out and refer to the schematic! If you don't have the manual or are awaiting delivery, don't I recall that you have another pin bank Seeburg that will be essentially the same - get the manual out for that one lol!

Norman.

[prime]

I do have the manual but it doest have any schematic showing those exact connections, I did some research and decided that wire could only have come from the leg the light was on, it seems to be a wire that feeds the counter. Ends up once i soldered it in both lights came on ,problem solved. pete