|
|
Post by grizzlydude on Feb 22, 2018 0:06:55 GMT
The manual says to divide the system by inserting a tester probe in pins 4,5,6, and 7 of wire side of green plug and scrape alligator clip on ground correct? But I'm not fully understanding this , do u run jumper wires to each pin or is it done one at a time until u have grounded all four?
|
|
|
|
Post by Ron Rich on Feb 22, 2018 17:28:27 GMT
Whut "Manual" are you reading ?? Ron Rich
|
|
|
|
Post by grizzlydude on Feb 23, 2018 0:47:06 GMT
At the back of Any digital phono manual in the troubleshooting section I will take a picture
|
|
|
|
Post by grizzlydude on Feb 23, 2018 0:58:38 GMT
|
|
|
|
Post by Ron Rich on Feb 23, 2018 1:31:27 GMT
Dude,
Attza not in ANY "Manual"--It may have been included by a "compiler",in a manual he sells, but as it says, (it is a two, or three page,) trouble shooting guide--which IMHO, is worthless, which is why I rit one myself ! OK--if you wish to follow that, use your "digital tester" as it says to do --If you wish, you may purchase a copy of my Seeburg MicroLog Trouble Shooting Guide( which BTW has a scanned copy of that doc. in it), please contact me off list at: ronnnrich@yahoo.com Ron Rich
|
|
