|
|
Post by continental55 on Sept 26, 2023 18:20:21 GMT
hi could I ask what voltage,amperage fuse types I should be using in the 3 fuse spots on the bottom of the power supply?
if wrong can it cause certain functions to not work properly? thanks
|
|
|
|
Post by Hildegard on Sept 26, 2023 20:04:25 GMT
Aren't the values (ampere) not written on the power supply or the caps of the fuses? You want to check that.
In general a jukebox "tells" what is needed.
The service manual resp. schematics lists these: 8A fast blo, 2A fast blo, 2x 1A slo-blo.
Usually fuses are or up to 250V.
If the ampere is wrong it can cause no or severe damage.
Too low: the fuse will burn though there is no problem. Because it doesn't meet the electrical needs.
Too high: The fuse will never burn in case of a problem. But then a transformer, motor, etc. might burn.
|
|
|
|
Post by continental55 on Sept 26, 2023 23:34:14 GMT
that makes sense I'll check those things out and thanks a lot for the help.
|
|
|
|
Post by continental55 on Sept 26, 2023 23:36:10 GMT
oops I forgot to ask does the 8 amp fast blo go in one of the 3 spots or inside the power supply?
|
|
|
|
Post by Hildegard on Sept 27, 2023 7:07:16 GMT
The 2A fuse is inside (underneath) of the junction box. The 8A and 2x 1A go in the three fuse holders on top.
But compare where the 8A has to be inserted - it does matter to find the right spot of the three.
If the lettering on the junction box is still there and readable, you should find this information.
|
|
