Question on brass tonearm bushing

continental55 Junior Member Posts: 50	Question on brass tonearm bushing Feb 1, 2024 2:20:37 GMT via mobile Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by continental55 on Feb 1, 2024 2:20:37 GMT Hi I got a brass bushing with a little bearing for my continental 2 as the wrong part was in there My question is do you put the bearing inside the bushing and then lower it onto the tonearm pin? Thanks

jukenorman Top Contributor Posts: 1,982	Question on brass tonearm bushing Feb 1, 2024 10:31:35 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by jukenorman on Feb 1, 2024 10:31:35 GMT Is this a serious question, does it not fit? Otherwise, some oil in the bushing will hold the ball bearing! Norman.
	Jukenorman, Aberdeen, Scotland, UK.

Deadhead Japan Junior Member Posts: 60	Question on brass tonearm bushing Feb 2, 2024 14:37:59 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Deadhead Japan on Feb 2, 2024 14:37:59 GMT Every small dab of silicone grease works well too. The same stuff used for the gripper gears. Neal