Coin Register Mechanism from Wurlitzer 2100 / 2000

[nessler]

Hello,

I own a Wurlitzer 2000 and from spare parts I managed to make a working coin registration mechanism.
However the originel wires were cut, which meant I had to solder a few things and use screw terminals.

I bought on ebay a near complete coin mechanism, listed as the 2000 version.
However when it came home, upon closer inspection, it appears to be from the 2100, and it has 2 differences.

One relay has a 200 ohm value instead of 30 ohm, and it has 3 switches instead of two, see the photo's below.
I already tested and connected the mechanism in the wurlitzer 2000 and everything works as it should, however,
when I found it it has these differences I was wondering if these are, at all, interchangeable ?

I wouldn't want to risk blowing fuses, or causing electric havok or anything...

I was hoping somebody here could tell me.

Kind regards, Nick.

[Ron Rich]

Hi Nick,
If the correct size/type, fuses are installed in your phono, I would not have any worries--
Ron Rich

[gamesmedic]

I'm looking for a coin mech relay solenoid for my 2600. It is also 200 Ohm. Testing the voltages for it were 28vdc. If if if makes any difference it controls the latch solenoid.

[Ron Rich]

Didja check the list of parts suppliers in the FAQ's above ?