201 no power to motor

[fireman110]

Hello,
I just replaced the motor run cap and the KCI-42 motor on the mech. The problem I'm having is the mech won't move no (power to the motor) I have 120v at the plug but the reversing switch has nothing??? Is there a fuse that I'm not seeing that powers the motor or maybe a resistor? The 5amp fuse on the terminal block of the mech isn't blown either...

[jukenorman]

Power for the motor is routed through the play control relay (located in the tormat selection receiver), the service switch should pull it in. The diagram of the power and control wiring, which should provide all the info you need to identify your problem, is on page 1338 of the manual.

Norman.

[fireman110]

The play contol Reay is energizing as it should either when a selection is made or when the service switch is moved to the left...

[fireman110]

Jun 11, 2024 10:16:08 GMT jukenorman said:

Power for the motor is routed through the play control relay (located in the tormat selection receiver), the service switch should pull it in. The diagram of the power and control wiring, which should provide all the info you need to identify your problem, is on page 1338 of the manual.

Norman.

Figured it out... the contacts were out of adjustment on the play control relay. It's back to "scan 2x and parked"

Now back to the other problems it has!