mjr
New Member
Posts: 5
|
Post by mjr on Aug 26, 2024 23:51:39 GMT
Hello Have Seeburg 100J. Rejects record as needle sets down. Or one or two seconds into play. Believe it’s mechanical problem. Trip lever does not trip. Saw post on this site. Have cleaned trip coil. Levers. Pulled clutch. Cleaned lubed. Went through Harold Hagens fix’s. Nothing seemed to be stuck or sticking. Went through clutch adjustments from manual. One through four. Problem is intermittent. Might be a little better since I’ve done cleaning and adjustments. But out of twelve plays or so. It did it three times. I’m posting right after making adjustments. Haven’t played a lot of records. I’m just frustrated. Is there something I’m missing. Is there a adjustment I can concentrate on. Any help would be great. Hope I explained well. Thanks Mark.
|
|
|
Post by jukenorman on Aug 27, 2024 8:24:48 GMT
It might be something as simple as the position of the trip solenoid? Or maybe the safety plunger? See page 2144 and 2145 of the manual.
Norman.
|
|
mjr
New Member
Posts: 5
|
Post by mjr on Aug 27, 2024 21:08:56 GMT
Hi Norman. Thanks for you advice. But I made it worse. All of the odd numbers will reject five or six Seconds into the song. The popularity And pinbank coil will energize. Then record Rejects. They both energize at start of Record. Then six seconds later. Do it again. Every once in awhile the even will reject at Start of record like before. And once or twice The popularity and reject coils energized and Stayed until record rejected. Also trip coil never Trips during these premature rejects. What Did I do. Thanks for your help Mark.
|
|
mjr
New Member
Posts: 5
|
Post by mjr on Aug 27, 2024 21:24:46 GMT
I’m not 100% sure this wasn’t doing this before I made those two adjustments. I was almost only Testing even records because I have a bad needle. I made the clutch adjustments before that. didn’t Test much. Because still had problems. That’s When I made the post.
|
|
mjr
New Member
Posts: 5
|
Post by mjr on Aug 27, 2024 23:40:56 GMT
Problem must be in the clutch. I can see the worm gear pin Barley rubbing on the clutch. Then grabbing and setting in Motion the reject. Thanks again
|
|
mjr
New Member
Posts: 5
|
Post by mjr on Aug 28, 2024 0:34:22 GMT
So pin in worm gear is loose. So when I adjusted pin pushed up. Then in play mode pin would drop hit clutch and Start reject. So I solved the odd problems. Played eight records Of even snd odd working so far. Quitting for the day. Can’t take Any more disappointment. You helped me. If I can reimburse you let me know. Thanks.
|
|