stephane54
New Member
Large collection of flipper, juke box and other games
Posts: 5
|
Post by stephane54 on Sept 29, 2024 2:16:38 GMT
Hello,
P'm looking for Wire Harness SMC1/2.
I have one Disco without it.
Thanks
Stephane
|
|
MOPARJOE
New Member
Cleveland, OH
Posts: 34 
|
Post by MOPARJOE on Sept 29, 2024 14:43:39 GMT
You are missing your entire harness for an SMC1, and have ALL the other parts/components that go inside the box?
|
|
stephane54
New Member
Large collection of flipper, juke box and other games
Posts: 5
|
Post by stephane54 on Oct 12, 2024 19:01:31 GMT
Yes I have all other parts and compobents.
I have the line cable to phono center and ballasts and horn wires to power amplifier.
I need all wires harness phono control center to memory bank control, microcomputer unit (new Ron Rich unit)
|
|
MOPARJOE
New Member
Cleveland, OH
Posts: 34
|
Post by MOPARJOE on Oct 14, 2024 9:44:53 GMT
I usually don't sell parts, as I have a LOT of these SMC machines, that hopefully I'll get to some day... You are welcome to send me your number (in a PM) to discuss exactly which harnesses you have, and see if we can work something out.
Thanks, Joe
|
|
MOPARJOE
New Member
Cleveland, OH
Posts: 34
|
Post by MOPARJOE on Oct 14, 2024 9:57:53 GMT
|
|
|
|
Post by jukeboxmarty on Oct 14, 2024 16:02:16 GMT
 Can't figure out how to post a picture on here
Check out this thread:
|
|
MOPARJOE
New Member
Cleveland, OH
Posts: 34
|
Post by MOPARJOE on Oct 14, 2024 17:21:33 GMT
|
|
stephane54
New Member
Large collection of flipper, juke box and other games
Posts: 5
|
Post by stephane54 on Oct 18, 2024 10:20:07 GMT
Hello Joe ,
Thank you for your proposition, but the subject is closed : I found complet wire harness !
Now the next problem is to find 311780 PCB. Mine is rev.A with coper draw very poor quality.
|
|
MOPARJOE
New Member
Cleveland, OH
Posts: 34
|
Post by MOPARJOE on Oct 18, 2024 14:43:09 GMT
Glad to hear you found a wiring harness... I have no ides what circuit board that part number is for, but I'm guessing it's for the MCU computer (only other board could be in the PCC)??.. If it is for the computer, then I'm also guessing you are working with/on the original computer, and did not buy a Gen-2 computer?... If you are indeed working on the original computer, I have several/many original computers here, but most are in non working condition, and my guy that you to repair them has not done any of for me in years now (hoping that will change at some point soon)... In any event, I would have a boards here to choose from, but would need to know which board, and how to tell what version it is.
Joe
|
|
