|
|
Post by paradisecs on Oct 18, 2018 19:05:58 GMT
The spring fell out of my reversing switch. I put it back but the mech now isn't reversing when it hits the brackets on either side, it just stops. If I lightly touch the blade it switches directions and continues on. Is the spring sprung and in need of replacement? The reversing brackets and stops haven't moved.
Stephen
|
|
|
|
Post by Ron Rich on Oct 18, 2018 20:19:54 GMT
Stephen,
Either the spring has "sprung" or the restraints are bent on the reversing switch-- see your service manual DRAWING-- restraints ( "upside-down V's") on either side MUST stop the "flipping motion" prior to the spring "flying"--then adjust switch as needed. Ron Rich
|
|
|
|
Post by paradisecs on Oct 18, 2018 23:42:41 GMT
Thanks Ron. It was the V. I must have bent one just enough to be causing the problem. Bent the forks back to parallel and it is working again.
Stephen
|
|
|
|
Post by Ron Rich on Oct 18, 2018 23:46:52 GMT
Stephen,
Whut-You tink I would lie to you ?? (glad you got-it !) Ron Rich
|
|
