Seeburg HSC Info Needed

[ilikeoldstuff]

I have an HSC-2, and I am working on the mech.
I pulled the clutch out, and following Ron's guide didn't let the (Diagram #34) Thrust Ball (Part 250 125)
 [AMR R-449Service Manual 2-2 Figure 42 Clutch Assembly][Exploded diagram found in Catalog# 605 505, page 13, Clutch Assembly]
 fall.

But when putting the clutch back in, the thrust ball is lost!
Does anyone know what I can replace this part with?


Also, looking at the motor mount dampers/isolation rubber, I am better off replacing them now.
Does anyone know who carries these replacement parts?

Motor: Seeburg 253 0585
Mech: 100 3S12T1 Code B

Thanks!

[Ron Rich]

Thanks for buying the Guide--not too much in there on the HSC's--
Steel ball is a hardware store item. A, .187 steel ball--dampers--another story--don't know who would have them--try Warren Rowe - 626 448-4518

[ilikeoldstuff]

Thanks Ron, that will help - couldn't survive without the guide!